CEN 1/8 M-Sport Ford Puma Rally RTR (GC8999)

559,00 € 599,00 € Risparmia 40,00 €
Tasse incluse

Experience modern RTR racing action just like in the real World Rally Championship with the "M-Sport Ford Puma Rally1" RC car by CEN Racing. This 1/8 scale ready-to-run (RTR) all-wheel-drive car replicates the rally car used since 2022 and comes with pre-installed electronics and 5 possible acceleration levels, reaching impressive speeds. The officially licensed body is faithfully designed with various logos. While the names of the two Estonian rally drivers are already printed on the side windows, additional included stickers allow You to proudly display the names of the French drivers instead.

Beneath the hood of the Ford Puma, there's a chassis made of 3mm thick aluminum, featuring supports and surrounding frames of the same material. This design effectively protects the electronics from gravel, dirt, and water splashes. The centrally located drive shaft ensures sufficient power is transmitted to the tires during driving. This results in an unforgettable driving experience, especially in corners, where the Ford Puma handles cleanly and enables impressive drifting maneuvers.

As an RTR model, all assembly work, including the finished body, is done at the factory. The standard version is designed for 2-3S LiPo batteries.


  • 4WD center shaft drive with metal gears
  • 3mm aluminum chassis with adjustable wheelbase +/- 6mm
  • Injection-molded rear diffuser
  • Aerodynamic design of the lower suspension arms
  • Center shaft drive with efficient power transfer to the wheels
  • High-quality transmission system
  • Lightweight and highly durable WRC Racing wheels
  • High-performance racing tires made from a special rubber compound
  • Controller with high-quality internal switching mode BEC with 6V / 7.4V for use with high-voltage servos
  • 5 acceleration and 9 maximum braking force levels
  • 3658 sensorless brushless motor with 3000KV
  • Hobbywing MAX10 SCT ESC with 100A (sensorless with T-plug)
    • Waterproof and dustproof
    • Includes a built-in capacitor module
    • Automatic throttle range calibration
    • Various protection functions
  • Savox 12kg servo with metal gears (25T)
    • 4.8V - 0.26 sec/60° 10.0 kg-cm
    • 6.0V - 0.23 sec/60° 12.0 kg-cm
  • AMP30 TX 3-channel transmitter
    • Digital trimming function
    • Dual-rate steering
    • Endpoint adjustment
    • Built-in failsafe function

Technical Specifications:

  • Length: 460mm
  • Width: 230mm
  • Wheelbase: 300mm
  • Ground clearance: 25mm
  • Weight: 2,5kg


Fully assembled rc car, incl.:

ESC Sensorless WP MAX10 SCT 100A controller for 3S with T-connector (Hobbywing)
Motor 3658 sensorless brushless motor, 3000kV (CEN Racing)
Servo 12kg metal gear servo (Savox)
Transmitter AMP30 TX 3-channel transmitter with corresponding receiver

Needed Accessories:

LiPo-Battery 2-3S and charger


1 Articolo



Riferimenti specifici